Can I turn off the front and rear lights on any of the helmets and only use the turn signals?

Follow

Comments

8 comments

  • Avatar
    Klaus Schädler

    Please note that for the Matrix helmet you don't have any possibility to customise the lights and you cannot use the turn signals only. The light settings on the dashboard are disabled (This function is not available for this helmet).

    0
    Comment actions Permalink
  • Avatar
    Jo Mrtns

    On My Ultra i can have the lights off and use the turn signals following this method BUT the lights automatically turn on when the turn signal is active. It's weird. 

    4
    Comment actions Permalink
  • Avatar
    jayson de groot

    The break sensor and the turning lights all turn on the lights.

    1
    Comment actions Permalink
  • Avatar
    Kees Mulder

    I have the same issue. The lights turn automatic on with the turn signal lights.

    The described procedure didn't change anything for my Lumos kickstart helmet.

    1
    Comment actions Permalink
  • Avatar
    jonarbel

    Anyway to enable only the front light and turn signal on the matrix. In other words nothing on rear display except turn signals. Thanks

    0
    Comment actions Permalink
  • Avatar
    Daniel Görgen

    Same problem here. Even if I turn off all lights, when I use the turn signals, lights go on and do so in boost mode. Is there any way to disable that behavior?

    1
    Comment actions Permalink
  • Avatar
    Kees Mulder

    I've still the same issue. 

    The lights turn automatic on with the turn signal lights.

    The charge led doesn't work either.

    0
    Comment actions Permalink
  • Avatar
    Mia Bontos

    Same issue here and the front light is so much brighter than the other two front lights that when I turn on the front turn signal, it’s barely visible since it’s positioned slightly behind the front light. I tried to find a solution to filter the front light without ruining the helmet design, and the only way I could fix it was by using a layer of grey carbon fiber wrap adhesive (like the ones used for cars) to cover it precisely. Now, when it turns on the brightness is the same as the side white leds and the helmet still looks beautiful. Hopefully, they’ll update the app so we can turn it off completely or at least remove the booster effect when the turn signal is active. I’ll remove the wrap then, but for now, that was the only solution.

    0
    Comment actions Permalink

Please sign in to leave a comment.

Powered by Zendesk